Kärcher K 2.7 Manuale Utente

English 2Español 17Français 335.961-627.0 04/05K 2.7

10 English"STEP 1:Turn the switch to OFF (0) position and unplug cord from outlet." STEP 2:Turn off the water source." STEP 3:Press tri

English 11" 1: Disconnect all water connections." 2: Turn on the machine for a few seconds, until the water which had remained in the pump e

12 English(with or without detergent). Pre-rinse cleaning surface with fresh water. If us-ing Kärcher Pressure Wash, apply to surface at low pressure

English 13sults, clean from top to bottom and from left to right. ! Before cleaning any surface an in-conspicuous area should be cleaned to test spray

14 EnglishMade with soft bristles that will not harm painted surfaces. Easily attaches direct-ly to the trigger gun. Ideal for stubborn dirt on cars,

English 15CAUTIONDisconnect the machine from the power source before making any repair.TROUBLESHOOTINGSymptom Cause SolutionMotor will not start On/O

16 EnglishCall: 1-800-537-4129 for help or visit our website: www.karcher-usa.comIf you encounter any additional difficul-ties not listed, please call

2 EnglishOverview 3Important Safety Instructions 4-5Assembly Instructions 6Operating Instructions 7GFCI Instructions 8Using the Accessories 8Working w

English 31 On/OFF switch2 Connector for detergent suction tube3 High pressure outlet4 Water inlet with garden hose connector5 Detergent suction tube w

4 English WARNINGWhen using this product basic precau-tions should always be followed, includ-ing the following:! Read all the instructions before us

English 5This product is supplied with a Ground Fault Circuit Interrupter (GFCI) built into the power cord plug. This device pro-vides additional prot

6 English"STEP 1, 2:" STEP 3, 4:" STEP 5, 6:" STEP 7, 8:" STEP 9:" STEP 10:Attach the high pressure hose to the trigger

English 7" STEP 1:Connect the high pressure hose to the unit’s high pressure outlet." STEP 2:Insert the spray wand of your choice to the tri

8 English"STEP 1: Plug the Ground Fault Cir-cuit Interrupter (GFCI) into a working outlet." STEP 2: Press ’’TEST’’, then press ’’RESET’’ to

English 9Detergents can only be applied at low pressure (Min.)." STEP 1:Install the vario power spray wand. Set the spray wand to the low pres-su